Desktop Injection Molding Machine Used three times total

Description

Manual Desktop Injection Molding Machine Used three times total. Condition is "Used". Shipped with UPS Ground.
Machine parameters:
- Power 0.3 kW
- Voltage 120V for US plug.
- The maximum temperature is 300 degrees Celsius.
- Electronic temperature controller (Shows temperature in degrees Celsius)
- The end of the nozzle is tapered, with an angle of 120 degrees
- Diameter of the hole in the nozzle 5 mm
- Maximum theoretical single injection volume 73 cubic centimeters (4.4 cubic inches)
!!! Note that the maximum theoretical single shot volume is the volume that can be squeezed out in one lever movement. But it is not equal to the volume of the product that you can get.
The maximum product that could be obtained is ~ 37 grams ~ 39 centimeters cubic ~ 2.38 cubic inches.
The main parameters that affect the size of the products that you can get:
- material and temperature of raw materials
- material and temperature of the form
- the size of the inlet in the mold.
- geometric characteristics of the form - the smaller the thickness of the walls, the more difficult it is to shed the form (for example, the handle for a screwdriver is much easier to make than a soap dish)
I test the machines before shipping, so there will be a small amount of plastic left in the cylinder.
Plastics you can use:
This machine can use plastic granules, shredded plastic and any plastic parts that fit into a 22 mm diameter cylinder.
You can work with any plastic that melts below 300 degrees Celsius, except PVC and PET.
Examples of some acceptable plastics:
HDPE, LDPE, PP, Acrylic, ABS,
Polycarbonate.
Plastics that cannot be handled with this machine:
PVC, nylon, PET.